Standing seam and metal panel roofing, roof repair and full replacement in Elkton. We show up when we say we will, and we clean up before we go.
Metal roofing is our specialty, but shingles, gutters, soffit and leak work all get the same attention in Elkton.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
Careful footwork, matched materials, and flashing done the way it was done when the roof went on.
Small repairs get the same crew and the same care as a full roof. Free estimate, a price in writing, and the work done before the next rain moves in.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
From a few tabs to a whole slope, we fix shingle roofs without pushing you toward a replacement you are not ready for.
Buying, selling, or just want to know how many years you have left? We look, we tell you, and we do not turn it into a pitch for a roof you do not need.
Underlayment, ice and water shield in the valleys and along the eaves, sealed penetrations, and proper closures at the ridge.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
New skylights set into metal or shingle roofs, with the flashing kit the roof actually calls for rather than a tube of sealant.
Ice backs up at a cold eave and pushes water sideways under the roof. We clear it without gouging the panels or the shingles.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
When a roof is genuinely finished we replace it, and we say so plainly rather than dressing it up. Metal and shingle priced side by side so you can compare real numbers.
Guards and screens so you are not up a ladder every fall digging pine needles out of the gutter by hand.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
A twenty year old panel roof usually needs fasteners and sealant, not replacement. We refasten with new washers and get you another long stretch out of it.
We work around your hours, weekends included when that is what it takes to keep your doors open while the roof goes on.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Elkton homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Elkton home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Here is what Elkton homeowners tell us makes the difference.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
The questions that come up on just about every estimate we write.
Much less than people expect. Over solid decking with underlayment under it, a Elkton metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
Plenty of them. Most Elkton customers choose from around twenty standard colors, and green, burgundy, bronze, black, gray, tan and barn red are the ones people pick most. We bring the color chart out with the estimate so you can hold it up against your siding.
Often, yes. Plenty of the Elkton roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
A typical Elkton shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
For most Elkton homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
Most Elkton houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
Real feedback from homeowners whose roofs we have worked on.
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"Roofing Brothers do excellent work. They've completed several projects for me and every time the quality has been top notch. They're reliable and take pride in what they do. I highly recommend them!"
"Cannot say enough about how careful they were around the flower beds. Everything got covered and nothing was trampled."
Our crews cover the surrounding area, not only the city limits.